Can I turn on/off RS-232 control from the front panel of an AVR/M processor?
YES – By pressing and holding the DIRECT button for about 5 seconds. This will toggle RS-232 Control ON or OFF. If the Control setting is set to IP then pressing the DIRECT button for 5 seconds will set Control to OFF, pressing the Direct button again will turn RS232 Control ON.
Related Articles
Triggering an RS 500 or RS 1000 amplifier on & off
There are a few ways to turn the RS amplifiers on and off, and depending on which one you wish to use, you might need to change. Trigger Methods Power Button The power button on the front panel of the unit will turn your RS amplifier on and put it ...
My Maestro processor or Concert receiver is on the network, but Dirac cannot find it!
First, make sure that the CONTROL setting in the setup menu is set to IP. Even if you will ultimately use RS-232 for control, the CONTROL setting needs to be set to IP in order for Dirac to see the processor or receiver on the network. For the ...
My Maestro processor or Concert receiver is on the network, but Dirac cannot find it!
First, make sure that the CONTROL setting in the setup menu is set to IP. Even if you will ultimately use RS-232 for control, the CONTROL setting needs to be set to IP in order for Dirac to see the processor or receiver on the network. For the ...
Can I turn the front LED’s off on my Pantages G3 or my Savoy G3?
To turn off the bouncing LED level indicators, all you have to do is press the “display” button on the front panel of the Savoy or Pantages. The channel indicator LED, at the very bottom of each channel will stay on. The “display” button will not ...
Dirac Live: Setup for Maestro M5/M9 processors and AVR 7/9 receivers
Initial Setup Make sure the AVR 7/9 or M5/9 is connected to the same network as your computer. It doesn’t matter if the computer is connected via hardware or wifi, as long as it is on the same network. If your network is DHCP, the amplifier will ...