[Control4] Videowall Controller

[Control4] Videowall Controller

Link to driver: Download Driver

Control System: Control4
Version: 114
Release Date: 16 JUN 2025

Supported Products:
  1. MXNET 1G 
  2. MXNET 10G
  3. AC-MX9XHDL-HDBT

Changelog:
v114:
ENHANCEMENTS: 
      - Added Support for 10G 
v113:
ADDED:
      - Added 1x2 and 1x4 videowalls that span the entire wall
      - Added 'Show 1 Source' option to videowall commands for 1x2 and 1x4 walls
BUGFIX:
      - Fixed screen position for 3x2 and 2x3 layouts, when a 2x2 videowall is active
v108:
ENHANCEMENTS: 
      - Increased max number of sources to 128
v107:
ENHANCEMENTS: 
      - Optimised Wall creation for MXNet from proxy SET_INPUT command
  eliminates sending second source switch command
v106:
ENHANCEMENTS: 
      - Added 2x4, 3x4, 4x2, 4x3 & 4x4 videowall options for MXNet

    • Related Articles

    • MXNet Control4: Videowall Setup Guide

      The following guide can be used to configure the MXNet driver within Control4. This guide requires the use of our MXNet driver version 12 or greater. You can find the latest version of the driver here. This guide is intended for an MXNet installation ...

    • FRESCO Video Wall Controller (Legacy)

      CAP-4 UNITS WITH A SERIAL NUMBER STARTING WITH 1207 HAVE A NEW HTTP GUI! Example: 120724042300004 Learn how to access here: AC-FRESCO-CAP-4 Manual Learn how to access here: AC-FRESCO-4X Manual Current Version V1.57 Software is for the following ...

    • Audio Bindings using Control4 and the MXNet Dante Controller

      Preamble The MXNet Dante Controller allows an integrator to implement a networked audio solution within the Control4 ecosystem. The MXNet Dante Controller can be used with any Dante Enabled device. For best results, ensure that the network switch is ...

    • AC-MXMV122-UHD Control & Configuration Software

      Current Version: V1.40 Updates: Cropping Added (Requires firmware V1.77) Fixed Audio Following with Preset Selection Control Switching, Multiview, and Configuration over RS232. Preset Duplication Software for transferring configurations to multiple ...

    • Tech Tip: Powering Devices On/Off with CEC

      CEC (Consumer Electronics Control) is a feature of HDMI designed to control multiple devices connected over HDMI by using a single remote controller. A common application of this is having a source, such as a Roku, connected to an AVR, then going out ...