Is the Dirac on/off command global, or per input?

Is the Dirac on/off command global, or per input?

The Dirac EQ on/off command is per input basis. You can disengage the Dirac EQ by pressing the “audio” button on the HTR-2 remote that came with your AVR or M9.  It is NOT a global command.

For example, if you turned on Dirac for your Satellite box input, then switch to your blue ray input, Dirac will be off, until you engage the EQ. After you engage the Dirac EQ on any given input, it will stay on, until you tell the unit to bypass.

    • Related Articles

    • Bass Control in Dirac Live

      Original PDF Version is attached to this article. This document covers Dirac Bass Control inside the Dirac Live application and is divided into two parts: Section 1: User Guide The first section is a user guide that goes through the work process of ...

    • Input Configuration settings: X / XR series processors and receivers

      The Input Configuration settings in the X series processors and XR series receivers allow you to optimize audio settings for each input depending on the type of source device you have connected to an input. To access the setup menu go to the front ...

    • Dirac Live: Setup for X / XR series processors and receivers

      This tutorial was written with Dirac version 3.4.4. Later versions of Dirac might have slight variations to the process. If you see something that doesn’t match with what you read in this guide, please call AudioControl tech support. The process for ...

    • Dirac Live - Filter Exporting issues

      After getting through the whole Dirac process, the installer may encounter a network error, or find that the filter just isn’t in the X-series. Here’s how we can help: 1. Try again! a. Before exiting Dirac, the installer should have saved a copy of ...

    • My Maestro processor or Concert receiver is on the network, but Dirac cannot find it!

      First, make sure that the CONTROL setting in the setup menu is set to IP. Even if you will ultimately use RS-232 for control, the CONTROL setting needs to be set to IP in order for Dirac to see the processor or receiver on the network. For the ...