SURFiR Operation Guide

SURFiR Operation Guide

Key Features of SURFiR:

  • Sleek and ergonomic design.
  • Companion remote for smartphones and tablets using the RTiPanel control app.
  • 433MHz and 2.4GHz Zigbee® RF transmission capability.
  • Fully customizable and programmable.
  • Security screw on the battery door for hotel applications.

Product Contents:

  • One (1) SURFiR Remote Control.
  • Four (4) AAA batteries.
  • One (1) Security screw removal tool.
  • Two (2) Button label lens covers (1 black - installed, 1 clear).
  • One (1) Sheet of remote ID labels.
  • One (1) Sheet of button labels.
  • Three (3) Battery door screws (Tri-head security).

Safety Suggestions:

  • Read and retain all safety and operating instructions.
  • Keep the unit away from heat sources and water.
  • Use only specified batteries.
  • Avoid object and liquid entry into the device.
  • Refer servicing to qualified personnel if the unit is damaged or not functioning properly.

Limited Warranty:

  • 3-year warranty (1 year for included battery packs) from the date of purchase.
  • Covers defects in material and workmanship.
  • Excludes damage from misuse, neglect, unauthorized repairs, and other specified causes.

Contacting RTI:

  • Website: www.rticontrol.com
  • Address: 5775 12th Ave. East, Suite 180, Shakopee, MN 55379.
  • Phone: (952) 253-3100.

Service & Support:

  • Contact RTI Technical Support via phone or email.
  • Provide details like name, product model, serial number, and a description of the issue.
  • Do not return products without authorization.

FCC Notice:

  • Complies with Part 15 of FCC Rules.
  • Operation subject to conditions preventing harmful interference.

Installing Batteries:

  1. Remove the battery door screw (if installed).
  2. Slide off the battery door.
  3. Insert four AAA batteries as per the diagram.
  4. Reinstall the battery door and optional security screw.

Installing Remote ID Label:

  1. Remove the remote label cover.
  2. Adhere the chosen label from the included sheet.
  3. Snap the label cover back into place.

Installing Button Labels:

  1. Remove the button label cover.
  2. Adhere labels to the designated areas.
  3. Snap the clear or black button label cover into place.

Programming the SURFiR:

  1. Enter Configuration Mode by holding the "Power" button for 10 seconds.
  2. Obtain the configuration code from Integration Designer® software.
  3. Enter the 10-digit code into the SURFiR using the numeric keypad.

LED Status Indicators:

  • Green: Command code being transmitted.
  • Red (slow blink): Low battery.
  • Red (fast blink): Critically low battery.
  • Red/Green alternating: Configuration Mode.