What is the minimum voltage needed to trigger Signal Sense on my Architect multi-zone amplifier?

• Related Articles

• How to use the 12 volt trigger options on an Architect amplifier.

  Architect amplifiers have both local zone 12 volt trigger connections and Master 12 volt trigger connections. The Local zone connection is a 3.5mm TS input connector. The Master trigger connection is either the 3-pin block connector or the two 3.5mm ...

• How to use signal sense on a CM-series 70V amplifier

  On the CM2-750, CM3-750, CM4-750, and their Dante-enabled counterparts, the zones can be turned on & off via IP command, 12V trigger, or Signal Sense. Check the following to make sure it works: Turn the zones ON. Turn global power ON, either via ...

• How to bridge amplifier channels on Director and Architect multi-zone home amps.

  Introduction AudioControl Director and Architect series amplifiers have the capability to bridge amplifier channels together to deliver more power to your speakers. Bridging amplifier channels combines a stereo pair of channels into a single mono ...

• Does Signal Sense work with Dante Inputs?

  Yes! If signal sense is On on your Dante amplifier and the zones are set to a Dante input, as soon as signal is sensed on that input the connected zones will turn on and output audio. Signal sensing does not actively switch inputs, so if a zone is ...

• Triggering an RS 500 or RS 1000 amplifier on & off

  There are a few ways to turn the RS amplifiers on and off, and depending on which one you wish to use, you might need to change. Trigger Methods Power Button The power button on the front panel of the unit will turn your RS amplifier on and put it ...