What port do I use to connect to my Director amplifier for IP Control?

• Related Articles

• What is the default IP address of my Director D/M, CM 70 volt, or RS series amplifier?

  Default IP Address of AudioControl Amplifiers The default IP address for our Director/Director Matrix distribution amplifiers, CM 70 volt amplifiers, and RS 500/1000 subwoofer amplifiers is 192.168.0.249. If the amplifier does not receive an IP ...

• How to use Groups on the Director amplifiers

  The AudioControl Director series amplifiers allow you to group 2 or more zones together so they act as one. This is useful if you have multiple sets of speakers for a single area, and you want them to all share the same input, volume level, and power ...

• Setting up Groups in a Director amplifier with Control4

  You may have multiple sets of speakers you want to control in single area in your distributed audio system, the Grouping feature in the Director amps is here to help. Combine this with Control4 for a seamless user experience. Set up your groups in ...

• How to use the Trim on a Director or CM amplifier

  Trim allows you to make small adjustments to the overall output level of a selected zone. You can find the trim controls on the right side of each zone, above the volume slider. In most circumstances, leaving it at 0 is the best bet, but there are ...

• Using the crossover on a Director Amplifier

  The following information applies to the Director D2800, D4600, M4800, M4840, M6400, and M6800 amplifiers, and does not apply to the Dante CM amplifiers. Each zone on the Director amplifier has a crossover control with that can be used to create a ...